Mould in Singapore Heritage Collections: Prevention and Recovery
Share
Short answer: mould grows when relative humidity (RH) stays high, so the way to prevent it is to keep collection spaces below about 65% RH at all times, including nights and weekends. If mould is found, isolate the affected items, wear protective equipment and dry them out before any cleaning.
Singapore's climate makes this a constant task. National Environment Agency figures published by the Department of Statistics put the 24-hour mean relative humidity between 76% and 82.6% in every year from 2016 to 2023, with a long-term annual mean temperature of 27.8°C. Outdoor air is well above the level conservators treat as safe, so museums, archives, schools, clan associations and private collectors all depend on controlled indoor conditions.
Why humidity, not temperature, decides mould risk
The Canadian Conservation Institute (CCI) explains that the route to controlling mould is to control moisture: without moisture, mould spores cannot grow. CCI gives 65% RH as the safe boundary usually cited to prevent mould growth, and states that below it mould will not grow at any temperature.
Above that boundary the clock starts. CCI notes that at 85% RH mould will probably appear in less than a week. Between 60% and 70% RH, the risk depends on temperature, which is why conservators look at both readings together.
In a Singapore building, the danger is rarely the average reading. It is the room where air-conditioning is switched off after hours, the store against an external wall, or the box left on the floor. Any of these can push RH well above the safe boundary for long enough to matter.
Find the microclimates before the mould does
CCI points out that colder spots have higher RH than warmer ones, and that RH near the output of humidifiers will be too high. It also warns that a wrapped package touching a cold wall can develop much higher RH at its cold end, which can lead to mould.
Practical checks for collection spaces:
- Log RH around the clock. Place data-logging hygrometers in each store and read the night-time and weekend data, not just office-hours spot checks.
- Keep boxes off floors and external walls. Leave an air gap so that cold surfaces do not create damp pockets.
- Watch the air-conditioning. Note when units cycle off and whether RH climbs afterwards.
- Use good enclosures. Acid-free boxes protect items from dust and handling, but they are not a substitute for a stable room.
Quarantine new arrivals
Donated collections, estate papers and items returned from loan are a common way for mould to enter a store. The National Archives (UK) advises institutions to isolate and examine new accessions on arrival to limit cross-contamination.
Set aside a separate, ventilated area for incoming material. Inspect each box for fuzzy growth, staining, a musty smell or items that feel damp, and only move material into the main store once it has been checked.
If you find mould: recovery steps from The National Archives (UK)
The National Archives' remediation guidance sets out a clear order of work:
- Assess first. Identify whether growth is active or inactive, because the two states carry different risks and need different approaches.
- Protect people. Full personal protective equipment (PPE) should always be worn when working with mould-affected material.
- Deactivate before treating. Treatment should not be undertaken while mould is active. Reduce humidity to deactivate it. For smaller outbreaks, the guidance suggests a local exhaust ventilation (LEV) cabinet for a minimum of 48 hours at below 50% RH, or a well-ventilated space away from the wider collection. Freezing may suit substantial outbreaks, but only with guidance from a conservation professional or recovery service.
- Dry with care. Fans and portable dehumidifiers can help, but drying too fast can cause mechanical damage such as cockling of paper.
- Clean inactive mould gently. Use a suction-controlled HEPA vacuum and soft natural-bristled brushes, working horizontally then vertically, with nylon mesh over fragile items. Cleaning removes only some loose mould and cannot remove staining.
- Avoid fungicides. Fungicidal and fungistatic treatments are not recommended without a conservation professional and a risk assessment.
- Clean up and follow up. Seal disposable materials and PPE in refuse bags for disposal outside the building, wipe surfaces with 70% industrial methylated spirit or ethanol in water, document what was found and plan spot checks.
Where digitisation fits
Mould staining cannot be cleaned away, so items that have survived an outbreak are often the ones most worth capturing digitally. Once material has been stabilised and is safe to handle, scanning gives researchers access without further handling, and a collections system such as Qi by Keepthinking keeps the images and records together.
Micrographics Data provides book scanning services, slide and negative scanning and customised acid-free boxing and encapsulation for heritage collections in Singapore.
Frequently asked questions
What relative humidity prevents mould in an archive?
The Canadian Conservation Institute gives 65% RH as the safe boundary usually cited to prevent mould growth, and states that below it mould will not grow at any temperature.
How quickly can mould appear at high humidity?
The Canadian Conservation Institute notes that at 85% RH mould will probably appear in less than a week.
Should we clean mouldy books straight away?
No. The National Archives (UK) advises that treatment should not be undertaken while mould is active. Reduce humidity to deactivate it first, wear full PPE and seek conservation advice for larger outbreaks.
Can fungicide sprays be used on mouldy documents?
The National Archives (UK) does not recommend fungicidal or fungistatic treatments, which need a conservation professional and a risk assessment.
Should mould-damaged items be digitised?
Once items have been stabilised and are safe to handle, digitisation gives access without further handling. Cleaning cannot remove mould staining, so a good digital copy protects the information the item carries.
Request a Quote
Planning to digitise or rehouse a collection after a humidity scare? Request a Quote from Micrographics Data, call +65 6472 7255 or email sales@micrographicsdata.com. Services delivered from Singapore; availability and delivery dates confirmed on each quotation.
Sources: Canadian Conservation Institute, "Damage caused by incorrect temperature and relative humidity"; The National Archives (UK), mould guidance: collection recovery and remediation; Department of Statistics Singapore / National Environment Agency, air temperature, sunshine, relative humidity and rainfall (annual).